Northern White Cedar vs. Red & White Pine

White Cedar Log SidingBlessed with natural preservatives, that make it one of the most decay / rot resistant and insect tolerant woods available. Minimal cracking and checking. Cracks will not penetrate the heartwood.

Not naturally resistant to rot or insects. Kiln-drying typically used to kill existing insects in wood. Requires preservative treatments to prevent future rot and insect damage; However, these treatments lose their abilities once the logs crack, opening up unprotected areas. Large cracks are common, often penetrating the heartwood.

According to a University of Maine study, initiated to determine the natural durability of various species of commonly used woods, untreated white cedar was found to possess a high natural durability, even underground contact conditions, as attested by the existence of surveyor's corner posts and rail fences still serviceable after 50-60 years or more.

The life expectancy of untreated wood species, (other than cedar) commonly used in log home construction, with ground contact, range from 3-7 years.

Has less moisture when green (3500 lbs. per cord), making it easier to reach desired moisture content levels. Cedar can be naturally air-dried to a 14-16% moisture level in a fairly short time. Air drying allows the wood to acclimate itself to the new moisture level without harming its' molecular structure.

Pine averages 4700 lbs. per cord immediately after harvest. The natural character of the wood is to retain moisture and in turn, release it very slowly if it is "forced out" unnaturally, risking possible cell rupture.

White cedar has the highest "R" value of any of the wood species used in log home production. A rating of 1.41 "R" / inch of thickness.

The "R" value of various pine species used in log production averages 1.12 "R" / inch of thickness.

According to the ASHRAE Handbook, the "R" Factor / Thermal Mass Factor of white cedar is 3.78. (Higher the number, the better).

According to the ASHRAE Handbook, the "R" Factor / Thermal Mass Factor of pine is 2.76.

Knot bleeding can occur when a knot contains an excessive amount of extractives. In these cases, the extractives consist mainly of rosin, fats and turpentine and these extraneous materials can make up as much as 50% of the knot by weight. The extractive percentage is higher or lower in different wood species. The extractive rich woods are primarily all pine (especially red pine), western red cedar and incense cedar.

Kiln drying wood can help reduce knot bleeding in pine, but it won't eliminate it. Droplets of pitch will occur in pine log siding when exposed to direct sun light or rain. The tendency for the knots to bleed will occur for many years, and they have been known to discharge resin for up to 50 years.

Source: www.michigancedarproducts.com

Cedar West Red Cedar Siding - Full Lifts Tongue and Groove / Profile: 1"x6" / 8'
Home Improvement (Cedar West)

You might also like:

Cedar Siding - Channel Rustic, …
Cedar Siding - Channel Rustic, …

My house had vinyl on it...

When I bought it 18 years ago. I've never heard it make any noise. I've never heard it flap in the wind and I've been through several hurricanes, including Katrina.
I haven't had to paint it, although I've had to wash it with a detergent/ bleach solution. Every corner post is broken near the bottom from the lawnmower. I've got a melted spot from the damn BBQ bit.
Overall, although I have some repairs to do, I'm happy with it. And I've put up quite a bit of wood siding in my life, red cedars, white cedars, clapboard, tongue and groove cedar, etc..

Related posts:

  1. Cedar siding for shed
  2. Vinyl Cedar siding prices
  3. Sheet Metal Siding Prices